A custom dealer programmer can be used on a BLACKCOMB 5.1/6.1 controller, to update the contact information and logos on the colour screens. Complete the following steps to use a dealer programmer.

1. Ensure that the controller is unplugged from the power outlet.

2. Plug the male end of the Programming Module into the female port on the controller

3. Plug the controller into an electrical outlet and allow the controller to power-up.

4. The controller will display, “Programming Screens, Please Wait...” for approximately 2 minutes.

5. Once the programming is completed, the unit will beep 3 times and then begin its normal start-up sequence.

6. Once step 5 is complete, power down the controller (unplug it) and remove the custom Dealer Programming module.

7. The screens have now been updated and the controller can be used as normal.

If a custom dealer programmer will not program a controller, please submit a ticket for support. New Ticket